HP (Hewlett-Packard) hn200w User Manual

 

 

How many IP addresses can the Gateway support? 

The Gateway supports a maximum of 253 IP addresses. 

Where is the Gateway installed on the network? 

In a typical environment, the Gateway is installed between the modem and the 
LAN. Plug the Gateway into the cable or DSL modem's Ethernet port.

Does the Gateway support any operating system other than Windows 95, 98, Me, 
2000, NT, or XP? 

Yes, but Hewlett-Packard does not provide technical support for setup, 
configuration, or troubleshooting of any non-Windows operating systems at this 
time.

If all else fails in the installation, what can I do?

Reset the Gateway by depressing the Reset button for at least three seconds, 
then reset your cable or DSL modem by powering the unit off and then back on. 
Obtain and flash (upload) the latest firmware release from the Hewlett-Packard 
Web site (www.hp.com).

Does the Gateway function in a Macintosh environment?

Yes, but the Gateway's setup pages are accessible only through Internet 
Explorer v4.0 or Netscape Navigator v4.0 or higher for Macintosh PCs.

I cannot get the Web configuration screen for the Gateway. What can I do?

You may have forgotten to remove the proxy server settings on your Internet 
browser, such as Netscape Navigator or Internet Explorer. Or, remove the dial-
up settings on your browser. Check your browser documentation.

Will the Gateway allow me to use my own public IP addresses and domain, or do I 
have to use the IP addresses provided by the Gateway?

The Gateway mode allows customization of your public IP addresses and 
domain.

How many ports can be simultaneously forwarded? 

Theoretically, the Gateway can establish 520 sessions at the same time, but you 
can only forward 10 ranges of ports.