Quatech WLNB-ET Series User Manual

 
100-8007-141G AirborneDirect™ 

Ethernet Bridge User's Guide 

Page 37 

LEAP Password 

Configures the WPA-LEAP password. 

 The LEAP password [1 to 32 characters] must match the 
LEAP password assigned to the LEAP user on the LEAP 
server.  

The LEAP password cannot contain spaces. 

Authentication 

Defines the type of key authentication, if any, to be used: 
•    Automatic  

– automatically detects the authentication 

 

 

 

 

 

    (default) 

•    Open System  – communicates the key across the 

 

 

 

 

    network 

•    Shared Key  – allows communication only with devices 

 

 

 

 

 

    with identical WEP settings 

Default Key 

Default WEP Key from 1 – 4 if Shared Key or Both is 
selected for Authentication. 
Default is WEP Key 1. 

WEP Key 1 through 4 

Up to four WEP key values. These values must be the same 
as the key implemented by the Access Point. 

•    If WEP Encryption = 64, enter 10 hexadecimal digits for 

each key. 

•    If WEP Encryption = 128, enter 26 hexadecimal digits for 

each key. 

Enable WPA Information Element 
format compatibility mode 

Controls the format of the WPA Information Element used in 
the Association Request management frame. Several brands 
of Access Points still use the legacy WPA format. 

When unchecked, enables the Legacy WPA Information 
Element format.  

When checked, enables the 802.1x WPA Information Element 
format. 

Default is unchecked. 

 
 

 

 

Module MAC Address 

Bridge’s MAC address. Default is factory set. Do not change 
this value; otherwise, unexpected results can occur

. 

Antenna Mode 

•    Ant2          – use primary antenna (J2)  (default) 
•    Diversity – allows the Bridge to select the antenna 

receiving the best quality signal.