RCA 360 User Manual
1 SpeedTouch™ Installation
E-DOC-CTC-20031204-0011 v2.0
12
1.3.2 USB Connection Setup for Microsoft Windows
Note
This section is only applicable for the SpeedTouch™360(i) product when connecting a
PC (running an MS Windows OS) through the device’s USB port.
PC (running an MS Windows OS) through the device’s USB port.
Supported Operating
Systems
Installing and using the SpeedTouch™ USB connection is supported for following
Microsoft Operating Systems:
Microsoft Operating Systems:
•
MS Windows 98/98SE
•
MS Windows Millennium
•
MS Windows 2000
•
MS Windows XP
You may need the Windows installation CD-ROM during installation.
Note
The installation procedures might be slightly different depending on the MS
Windows OS you are using:
Windows OS you are using:
System requirements
•
For Windows 98/98SE/ME:
•
Pentium processor 166 MHz or compatible
•
32 megabytes (MB) of memory
•
For Windows 2000/XP:
•
Pentium II processor or compatible
•
64 MB of memory
•
30 MB of free disk space
Prerequisites
Make sure to remove any SpeedTouch™ USB driver installation that may reside on your
PC before you install the USB drivers from the SpeedTouch™ Setup CD-ROM deliv-
ered with your SpeedTouch™360(i) product.
Make sure both your PC and SpeedTouch™ are turned on and operational.
PC before you install the USB drivers from the SpeedTouch™ Setup CD-ROM deliv-
ered with your SpeedTouch™360(i) product.
Make sure both your PC and SpeedTouch™ are turned on and operational.
Installing the
SpeedTouch™ USB
connection
The installation is Plug and Play, meaning that installation will require almost no effort.
Proceed as follows
Proceed as follows
1
Insert the USB cable provided into the SpeedTouch™ USB port marked with the
USB logo:
USB logo:
.
2
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
most cases your PC's USB port is marked with the same USB symbol.
most cases your PC's USB port is marked with the same USB symbol.
Note
You can also connect your PC to the SpeedTouch™ via a USB hub.