TP-LINK TL-WA750RE User Manual
TL-WA750RE
150Mbps Universal WiFi Range Extender User Guide
¾
Beacon Interval - Specifies a value between 40-1000 milliseconds. The beacons are the
packets sent by the device to synchronize a wireless network. Beacon Interval value
determines the time interval of the beacons. The default value is 100.
packets sent by the device to synchronize a wireless network. Beacon Interval value
determines the time interval of the beacons. The default value is 100.
¾
RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger
than the specified RTS Threshold size, the device will send RTS frames to a particular
receiving station and negotiate the sending of a data frame. The default value is 2346.
than the specified RTS Threshold size, the device will send RTS frames to a particular
receiving station and negotiate the sending of a data frame. The default value is 2346.
¾
Fragmentation Threshold - This value is the maximum size determining whether packets
will be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance since excessive packets. 2346 is the default setting and is recommended.
will be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance since excessive packets. 2346 is the default setting and is recommended.
¾
DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM).
You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
¾
Enable WMM - WMM function can guarantee the packets with high- priority messages being
transmitted preferentially. It is strongly recommended enabled.
transmitted preferentially. It is strongly recommended enabled.
¾
Enable Short GI - This function is recommended for it will increase the data capacity by
reducing the guard interval time.
reducing the guard interval time.
¾
Enable AP Isolation - Isolates all connected wireless stations so that wireless stations
cannot access each other through WLAN.
cannot access each other through WLAN.
4.5.5 Wireless Statistics
Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission
information in the following screen shown in Figure 4-18.
information in the following screen shown in Figure 4-18.
Figure 4-18 Statistics of the device attached wireless stations
¾
Operation Mode - Shows the current operation mode.
¾
MAC Address - Shows the connected wireless station's MAC address.
¾
Current Status - The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected.
Disconnected.
¾
Received Packets - packets received by the station.
¾
Sent Packets - packets sent by the station.
23