Buffalo Technology WLI-TX4-G54HP User Manual

If your wireless router/access point doesn't support AOSS, you'll 

need to configure the access point manually.  There are two ways 

to do this:  you can use the Ethernet Converter Manager software 

if you have a Windows PC on the network (98/ME/2000/XP only), 

or you may use a web browser.  Web browser configuration may be 

done with any computer running a recent web browser, including 

Macintosh and Linux machines (Skip to page 7 for web based config).

If you have a Windows 98/ME/2000/XP machine with a CD-ROM 

drive available on your computer network, the Ethernet Converter 

Manager makes it simple to configure the Ethernet Converter.  The 

following steps will guide you through configuring the Ethernet 

Converter via the Ethernet Converter Manager.

•

  Connect one of the Ethernet Converter's LAN ports to an open 

port on your network's router, switch or hub with the included 

network patch cable.  If there are no ports available, you can 

temporarily remove a computer or other connected device and plug 

the Ethernet Converter to that port.  You can plug the Ethernet 

Converter directly to the configuring computer, but will have to 

configure settings manually as described on page 8.

•

  Once the network cable has been plugged in, plug the Ethernet 

Converter's AC Adapter into an available power outlet.  Then 

attach the power connector to the back of the Ethernet Converter.  

The boot up process takes 30 seconds and is complete when both 

the Wireless and Ethernet LEDs are lit.

•

  Return to the PC designated for configuration and insert the 

included Ethernet Converter CD-ROM into the PC's CD-ROM drive.

•

  The Ethernet Converter Utility should launch automatically.  If 

it does not, browse your CD-ROM drive in Windows and run the 

setup.exe program.