ZyXEL Communications NBG-416N User Manual
Chapter 3 Connection Wizard
NBG-416N User’s Guide
26
3.3 Connection Wizard: STEP 2: Wireless LAN
Set up your wireless LAN using the following screen.
Figure 10 Wizard Step 2: Wireless LAN
The following table describes the labels in this screen.
Note: The wireless stations and NBG-416N must use the same SSID, channel ID,
WPA-PSK (if WPA-PSK is enabled) or WPA2-PSK (if WPA2-PSK is enabled) for
wireless communication.
wireless communication.
Table 4 Wizard Step 2: Wireless LAN
LABEL
DESCRIPTION
Name
(SSID)
(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the
wireless LAN.
wireless LAN.
If you change this field on the NBG-416N, make sure all wireless stations
use the same SSID in order to access the network.
use the same SSID in order to access the network.
Security
Select a Security level from the drop-down list box.
Choose None to have no wireless LAN security configured. If you do not
enable any wireless security on your NBG-416N, your network is accessible
to any wireless networking device that is within range. If you choose this
option, skip directly to
enable any wireless security on your NBG-416N, your network is accessible
to any wireless networking device that is within range. If you choose this
option, skip directly to
.
Choose WPA-PSK or WPA2-PSK security to configure a Pre-Shared Key.
Choose this option only if your wireless clients support WPA-PSK or WPA2-
PSK respectively. If you choose this option, skip directly to
Choose this option only if your wireless clients support WPA-PSK or WPA2-
PSK respectively. If you choose this option, skip directly to
Channel
Selection
Selection
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices
is called a channel.
is called a channel.
Auto
Channel
Selection
Channel
Selection
Select this for the NBG-418N to automatically choose the channel with the
least interference. Deselect this if you wish to manually select the channel
using the Channel Selection field.
least interference. Deselect this if you wish to manually select the channel
using the Channel Selection field.
Back
Click Back to display the previous screen.
Next
Click Next to proceed to the next screen.
Exit
Click Exit to close the wizard screen without saving.