ZyXEL Communications P-793H User Manual

Chapter 28 NAT Setup

P-793H User’s Guide

Figure 169   Menu 15.1.1.1: Address Mapping Rule

The following table describes the fields in this menu.

"

If you do not assign a Default Server IP address, the ZyXEL Device discards 
all packets received for ports that are not specified here or in the remote 
management setup.

                    Menu 15.1.1.1 Address Mapping Rule

                    Type= Server

                    Local IP:
                      Start= N/A
                      End  = N/A

                    Global IP:
                      Start= 0.0.0.0
                      End  = N/A

                    Server Mapping Set= 2

Table 112   Menu 15.1.1.1: Address Mapping Rule

Type

Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are the 

mapping types discussed in 

. Server allows you to specify multiple 

servers of different types behind NAT to this computer. See 

 

for 

an example.

Local IP

These fields are enabled depending on the Type.

Start

Enter the starting local IP address (ILA).

End

Enter the ending local IP address (ILA). If the rule is for all local IPs, then put the Start IP 

as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and Server 

types.

Global IP

These fields are enabled depending on the Type.

Start

Enter the starting global IP address (IGA). If you have a dynamic IP, enter 0.0.0.0 as the 

Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if the types are Many-

to-One or Server.

End

Enter the ending global IP address (IGA). This field is N/A for One-to-One, Many-to-One 

and Server types.

Server 

Mapping 

Set

This field is available only when you select Server in the Type field. Select which server 

mapping set to use for this rule.

Once you have finished configuring a rule in this menu, press [ENTER] at the message “Press ENTER 

to Confirm…” to save your configuration, or press [ESC] to cancel.