ZyXEL Communications P-793H User Manual

Chapter 35 Menus 24.8 to 24.11

P-793H User’s Guide

Figure 236   Menu 24.11 – Remote Management Control

The following table describes the fields in this screen.

Remote management over LAN or WAN will not work when:

1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or 

Web service. 

2 You have disabled that service in menu 24.11.
3 The IP address in the Secure Client IP field (menu 24.11) does not match the client IP 

address. If it does not match, the ZyXEL Device will disconnect the session 
immediately.

4 There is an SMT console session running.
5 There is already another remote management session with an equal or higher priority 

running. You may only have one remote management session running at one time. 

6 There is a firewall rule that blocks it.

                     Menu 24.11 - Remote Management Control

     TELNET Server:
       Server Port = 23                   Server Access = ALL
       Secured Client IP = 0.0.0.0

     FTP Server:
       Server Port = 21                   Server Access = ALL
       Secured Client IP = 0.0.0.0

     Web Server:
       Server Port = 80                   Server Access = ALL
       Secured Client IP = 0.0.0.0

Table 129   Menu 24.11 – Remote Management Control

TELNET Server
FTP Server
Web Server

Each of these read-only labels denotes a service that you may use to remotely 

manage the ZyXEL Device.

Server Port

This field shows the port number for the service or protocol. You may change the 

port number if needed, but you must use the same port number to access the 

ZyXEL Device.

Server Access

Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to 

choose from: LAN only, WAN only, ALL or Disable.

Secured Client 

IP

The default 0.0.0.0 allows any client to use this service to remotely manage the 

ZyXEL Device. Enter an IP address to restrict access to a client with a matching IP 

address.

Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to 

Cancel" to save your configuration, or press [ESC] to cancel.