ZyXEL Communications P-793H User Manual

Chapter 36 IP Routing Policy Setup

P-793H User’s Guide

Use this menu to configure policy routes. To open this menu, select Edit and enter the 
appropriate rule number in menu 25.

Figure 239   Menu 25.1.1: IP Routing Policy

The following table describes the labels in this menu.

                         Menu 25.1.1 - IP Routing Policy

          Policy Set Name= ex1
          Active= No
          Criteria:
            IP Protocol    = 0
            Type of Service= Don't Care           Packet length= 0
            Precedence     = Don't Care             Len Comp= N/A
            Source:
              addr start= 0.0.0.0                 end= N/A
              port start= N/A                     end= N/A
            Destination:
              addr start= 0.0.0.0                 end= N/A
              port start= N/A                     end= N/A
          Action= Matched
            Gateway addr   = 0.0.0.0              Log= No
            Type of Service= No Change
            Precedence     = No Change

Table 132   Menu 25.1.1: IP Routing Policy

Policy Set Name

This is the descriptive name of the routing policy selected in Menu 25.1 - IP 

Routing Policy Summary.

Active

Press [SPACE BAR] and then [ENTER] to select Yes to activate the policy.

Criteria

IP Protocol

Enter a number that represents an IP layer 4 protocol, for example, UDP=17, 

TCP=6, ICMP=1 and Don't care=0.

Type of Service

Prioritize incoming network traffic by choosing from Don't Care, Normal, Min 

Delay, Max Thruput or Max Reliable.

Precedence

Precedence value of the incoming packet. Press [SPACE BAR] and then 

[ENTER] to select a value from 0 to 7 or Don't Care.

Packet Length

Type the length of incoming packets (in bytes). The operators in the Len 

Comp (next field) apply to packets of this length.

Len Comp

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, 

Less, Greater, Less or Equal or Greater or Equal.

Source

addr start / end

Source IP address range from start to end.

port start / end

Source port number range from start to end; applicable only for TCP/UDP.

Destination

addr start / end

Destination IP address range from start to end.

port start / end

Destination port number range from start to end; applicable only for TCP/UDP.