ZyXEL Communications P-793H User Manual

Chapter 5 WAN Setup

P-793H User’s Guide

Figure 30   WAN > More Connections > Edit

The following table describes the labels in this screen. 

Table 19   WAN > More Connections > Edit

General

Active

Select the check box to activate or clear the check box to deactivate this 

connection.

Name

Enter a unique, descriptive name of up to 13 ASCII characters for this 

connection.

Mode

Select Routing from the drop-down list box if your ISP allows multiple 

computers to share an Internet account. 
If you select Bridge, the ZyXEL Device will forward any packet that it does not 

route to this remote node; otherwise, the packets are discarded.

Encapsulation

Select the method of encapsulation used by your ISP from the drop-down list 

box. Choices are PPPoA, RFC 1483, ENET ENCAP or PPPoE.
If you set up a point-to-point connection, select either ENET ENCAP or RFC 

1483.

User Name 

(PPPoA and PPPoE encapsulation only) Enter the user name exactly as your 

ISP assigned. If assigned a name in the form user@domain where domain 

identifies a service name, then enter both components exactly as given.

Password

(PPPoA and PPPoE encapsulation only) Enter the password associated with the 

user name above.

Service Name

(PPPoE only) Type the name of your PPPoE service here.