ZyXEL Communications P-662H User Manual

P-662H/HW-D Series User’s Guide

Chapter 7 Wireless LAN

149

The following table gives a description of multiple SSID commands. 

Table 49   Multiple SSID Commands

guestssid <SSID>

Use this command to specify the SSID of the guest wireless network. This is 

the SSID guests have to configure on their wireless clients to connect to 

your wireless network. Type a descriptive name (up to 32 printable 7-bit 

ASCII characters) for the wireless LAN.

mode [0:disable 
guestssid 1:enable 
guestssid] 

[0:disable intranet 
blocking 1:enable 
intranet blocking]

This command performs two functions and is followed by two parameters. 
The first parameter specifies whether you want to enable or disable your 

guest wireless network. Type 0 to disable the guest wireless network or type 

1 to enable the guest wireless network.
The second parameter specifies whether you want to block guests in the 

guest wireless network from accessing resources on your LAN. Type 0 to 

allow guests to access resources on your LAN or type 1 to block guests 

from accessing resources on your LAN and only allow access to the Internet 

via the ZyXEL Device.

setprivacy type 
<0:NO 1:WEP64 
2:WEP128 3:WEP256>

This command specifies the security mode for the guest wireless network.
Type one of the following: 
0 to disable security on the guest wireless network,
1 to enable 64-bit WEP key encryption,
2 to enable 128-bit WEP key encryption,
3 256-bit WEP key encryption. 

setprivacy wepkey 
<1-4> <Key String>

This command allows you to create up to four WEP keys. Enter 1, 2, 3 or 4 

to specify which WEP key you are creating followed by any 5, 13 or 29 

characters (ASCII string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-

F") for a 64-bit, 128-bit or 256-bit WEP key respectively.

setprivacy 
defaultkey <1-4> 

This command specifies which WEP key guests have to configure on their 

wireless clients to access the guest wireless network. 

guest_autoOff < 
<1:on, 0:off> 
<Timeout (minutes), 
0 for default>  

This command enables or disables an automatic timeout feature of the 

guest wireless network. If you enable this feature the guest wireless network 

becomes disabled after the specified amount of time. You need to enter two 

parameters.
Type 0 to disable the automatic timeout feature or type 1 to enable it, for the 

next value enter the number of minutes that the guest wireless network 

stays active. Enter a number from 0 to 30000. Entering 0 resets the value to 

the default (60 minutes).

Note: This command is hidden. It doesn’t show up when you 

type the 

wlan mssid

 command.

show

This command allows you to review your guest wireless network settings.