ZyXEL Communications P660HN-Fx User Manual

Chapter 8 Routing

ADSL Series User’s Guide

Network Setting > Routing

The following table describes the labels in this screen. 

Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The 
following screen appears. Use this screen to configure the required information for a static route.

Routing: Add/Edit

Network Setting > Routing

Add New Static 
Route

Click this to set up a new static route on the ZyXEL Device.

#

This is the number of an individual static route.

Active

This indicates whether the rule is active or not.

A yellow bulb signifies that this static route is active. A gray bulb signifies that this static 
route is not active.

Status

This shows whether the static route is currently in use or not. A yellow bulb signifies that 
this static route is in use. A gray bulb signifies that this static route is not in use. 

Name

This is the name that describes or identifies this route. 

Destination IP

This parameter specifies the IP network address of the final destination. Routing is always 
based on network number. 

Gateway

This is the IP address of the gateway. The gateway is a router or switch on the same 
network segment as the device's LAN or WAN port. The gateway helps forward packets to 
their destinations.

Subnet Mask

This parameter specifies the IP network subnet mask of the final destination.

Interface

This is the WAN interface through which the traffic is routed. 

Modify

Click the Edit icon to go to the screen where you can set up a static route on the ZyXEL 
Device.

Click the Delete icon to remove a static route from the ZyXEL Device.