ZyXEL Communications NWA3000-N User Manual

 Chapter 16 Log and Report

NWA3000-N Series User’s Guide

The following table describes the fields in this screen.  

Table 86   Configuration > Log & Report > Log Setting > Active Log Summary

Active Log 
Summary 

If the NWA3000-N series AP is set to controller mode, the AC section 
controls logs generated by the controller and the AP section controls logs 
generated by the managed APs.

System log

Use the System Log drop-down list to change the log settings for all of 
the log categories.

disable all logs (red X) - do not log any information for any category 
for the system log or e-mail any logs to e-mail server 1 or 2.

enable normal logs (green check mark) - create log messages and 
alerts for all categories for the system log. If e-mail server 1 or 2 also 
has normal logs enabled, the NWA3000-N series AP will e-mail logs to 
them.

enable normal logs and debug logs (yellow check mark) - create log 
messages, alerts, and debugging information for all categories. The 
NWA3000-N series AP does not e-mail debugging information, even if 
this setting is selected.

E-mail Server 
1

Use the E-Mail Server 1 drop-down list to change the settings for e-
mailing logs to e-mail server 1 for all log categories.

Using the System Log drop-down list to disable all logs overrides your 
e-mail server 1 settings.

enable normal logs (green check mark) - e-mail log messages for all 
categories to e-mail server 1.

enable alert logs (red exclamation point) - e-mail alerts for all 
categories to e-mail server 1.

E-mail Server 
2

Use the E-Mail Server 2 drop-down list to change the settings for e-
mailing logs to e-mail server 2 for all log categories.

Using the System Log drop-down list to disable all logs overrides your 
e-mail server 2 settings.

enable normal logs (green check mark) - e-mail log messages for all 
categories to e-mail server 2.

enable alert logs (red exclamation point) - e-mail alerts for all 
categories to e-mail server 2.

Remote Server 
1~4

For each remote server, use the Selection drop-down list to change the 
log settings for all of the log categories.

disable all logs (red X) - do not send the remote server logs for any log 
category.

enable normal logs (green check mark) - send the remote server log 
messages and alerts for all log categories. 

enable normal logs and debug logs (yellow check mark) - send the 
remote server log messages, alerts, and debugging information for all 
log categories. 

#

This field is a sequential value, and it is not associated with a specific 
address.