ZyXEL Communications NBG-419N User Manual
Chapter 7 Easy Mode
NBG-419N v2 User’s Guide
59
Note: You can enable the Wireless function of your Router by first turning on the switch in
the back panel.
Figure 41
Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 26
Wireless Security
LABEL
DESCRIPTION
Wireless
Network Name
(SSID)
Network Name
(SSID)
(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
associated. Wireless stations associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
Security mode
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears in this screen.
clients which want to associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears in this screen.
Select No Security to allow any client to connect to this network without authentication.
Wireless
password
password
This field appears when you choose wither WPA-PSK or WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Verify password Type the password again to confirm.
Apply
Click Apply to save your changes back to the Router.
Cancel
Click Cancel to close this screen.
WPS
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen) to
another wireless device that supports WPS.
another wireless device that supports WPS.