ZyXEL Communications NBG-419N User Manual
Chapter 9 Access Point Mode
NBG-419N v2 User’s Guide
70
9.3.1 Setting your Router to AP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on
how to do this.
how to do this.
2
To use your Router as an access point, go to Maintenance > Sys OP Mode > General and select
Access Point mode.
Access Point mode.
Figure 48
Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your Router is already in Access Point mode.
3
When you select Access Point Mode, the following pop-up message window appears.
Figure 49
Pop up for Access Point mode
Click OK. The Web Configurator refreshes once the change to Access Point mode is successful.
9.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1
Connect your computer to the LAN port of the Router.
2
The default IP address of the Router is “192.168.1.2”. In this case, your computer must have an IP
address in the range between “192.168.1.3” and “192.168.1.254”.
address in the range between “192.168.1.3” and “192.168.1.254”.
3
Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to
show your computer’s IP address. If your computer’s IP address is not in the correct range then see
show your computer’s IP address. If your computer’s IP address is not in the correct range then see
for information on changing your computer’s IP address.