ZyXEL Communications HS100/HS100W User Manual
HomeSafe User’s Guide
Menu 2 WAN Setup
19-1
Chapter 19
Menu 2 WAN Setup
This chapter describes how to configure the WAN using menu 2.
19.1 Introduction to WAN
This chapter explains how to configure settings for your WAN port.
19.2 WAN Setup
From the main menu, enter 2 to open menu 2.
Figure 19-1 Menu 2 WAN Setup
The following table describes the fields in this menu.
Table 19-1 Menu 2 WAN Setup
FIELD
DESCRIPTION
MAC Address
Assigned By
Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned default MAC
Address. Choose IP address attached on LAN to use the MAC Address of that
computer whose IP you give in the following field.
MAC Address. Choose Factory Default to select the factory assigned default MAC
Address. Choose IP address attached on LAN to use the MAC Address of that
computer whose IP you give in the following field.
IP Address
This field is applicable only if you choose the IP address attached on LAN method in
the Assigned By field. Enter the IP address of the computer on the LAN whose MAC
you are cloning.
the Assigned By field. Enter the IP address of the computer on the LAN whose MAC
you are cloning.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
your configuration, or press [ESC] at any time to cancel.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to Cancel: