ZyXEL Communications ISG50 User Manual

Chapter 23 Firewall

ISG50 User’s Guide

The following table describes the labels in this screen.    

Configuration > Firewall > Session Limit > Edit

Create new 
Object

Use to configure any new settings objects that you need to use in this screen.

Enable Rule

Select this check box to turn on this session limit rule. 

Description

Enter information to help you identify this rule. Use up to 64 printable ASCII 
characters. Spaces are allowed. 

User

Select a user name or user group to which to apply the rule. The rule is activated 
only when the specified user logs into the system and the rule will be disabled 
when the user logs out.

Otherwise, select any and there is no need for user logging.

Note: If you specified an IP address (or address group) instead of any in the field 

below, the user’s IP address should be within the IP address range.

Address

Select a source address or address group for whom this rule applies.  Select any 
if the policy is effective for every source address.

Session Limit per 
Host

Use this field to set a limit to the number of concurrent NAT/firewall sessions this 
rule’s users or addresses can have.

For this rule’s users and addresses, this setting overrides the

 

 

setting in the general Firewall Session Limit

 

screen.

OK

Click OK to save your customized settings and exit this screen.

Cancel

Click Cancel to exit this screen without saving.