ZyXEL Communications ISG50 User Manual
Chapter 34 Call Services
ISG50 User’s Guide
542
34.7.1 Configuring the Call Transfer Screen
Use this screen to configure call transfer on the ISG50. Click Configuration > PBX > Call Service
> Call Transfer to open the screen as following.
> Call Transfer to open the screen as following.
Figure 362
Configuration > PBX > Call Service > Call Transfer
The following table describes the labels in this screen.
34.8 The Call Block Screen
Use this screen to have the ISG50 not accept incoming calls from specific phone numbers or calls
without caller ID. Click Configuration > PBX > Call Service > Call Block to view the screen as
shown next.
without caller ID. Click Configuration > PBX > Call Service > Call Block to view the screen as
shown next.
Figure 363
Configuration > PBX > Call Service > Call Block
Table 197
Configuration > PBX > Call Service > Call Transfer
LABEL
DESCRIPTION
Interdigit
timeout
timeout
Enter the maximum number of seconds (1-30) the ISG50 waits for each digit input of a
complete callee number after you press the flash key on the phone. If the ISG50 cannot
receive the next digit entered within this time period, the ISG50 processes digits you have
dialed.
complete callee number after you press the flash key on the phone. If the ISG50 cannot
receive the next digit entered within this time period, the ISG50 processes digits you have
dialed.
Enable Call
Transfer Local
Handling
Transfer Local
Handling
Select this to allow a caller to transfer a current external call (via an outbound line group)
to another extension. Otherwise, clear it to not allow this.
to another extension. Otherwise, clear it to not allow this.
Apply
Click this to save your changes and to apply them to the ISG50.
Reset
Click this to set every field in this screen to its last-saved value.