ZyXEL Communications G-570S User Manual

ZyXEL G-570S User’s Guide

Chapter 2 Management Computer Setup

33

Note: The wireless stations and G-570S must use the same SSID, channel and 

wireless security settings for wireless communication.

If you do not enable any wireless security on your G-570S, your network traffic 
is visible to any wireless networking device that is within range. 

Press and immediately release the RESET button to restart the G-570S.

Note: Holding the RESET button in for five seconds or longer resets the device to the 

factory-default settings.

If you forget the G-570S's IP address or your password, to access the G-570S, you will need to 
reload the factory-default using the RESET button. Resetting the G-570S replaces the current 
configuration file with the factory-default configuration file. This means that you will lose all 
configurations that you had previously. The following parameters will be reset to the default 
values.

You can erase the current configuration and restore factory defaults in two ways: 

1 Use the RESET button on the G-570S to upload the default configuration file (hold this 

button in for at least five seconds). 

2 Use the web configurator to restore defaults. Click SYSTEM > Management > 

Configuration File. From here you can restore the G-570S to factory defaults. 

Table 2   Factory Defaults

IP Address

192.168.1.2

Password

1234

Wireless Security

Disabled

SSID

ZyXEL G-570S