ZyXEL Communications LTE6100 User Manual

 Chapter 6 Routing

LTE6100 User’s Guide

Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The 
following screen appears. Use this screen to configure the required information for a static route.

Routing: Add/Edit

The following table describes the labels in this screen. 

Routing: Add/Edit

Active

Click this to activate this static route.

Route Name

Enter the name of the IP static route. Leave this field blank to delete this static route.

Destination IP 
Address

This parameter specifies the IP network address of the final destination.  Routing is always 
based on network number. If you need to specify a route to a single host, use a subnet 
mask of 255.255.255.255 in the subnet mask field to force the network number to be 
identical to the host ID.

IP Subnet Mask  Enter the IP subnet mask here.

Gateway IP 
Address

You can decide if you want to forward packets to a gateway IP address or a bound 
interface.

If you want to configure Gateway IP Address, enter the IP address of the next-hop 
gateway. The gateway is a router or switch on the same network segment as the device's 
LAN or WAN port. The gateway helps forward packets to their destinations.

Bound Interface

You can decide if you want to forward packets to a gateway IP address or a bound 
interface.

If you want to configure Bound Interface, select the check box and choose an interface 
through which the traffic is sent.

Apply

Click Apply to save your changes.

Back

Click Back to exit this screen without saving.