ZyXEL Communications G-3000H User Manual

G-3000H User’s Guide

Chapter 17 LAN Setup

181

Figure 110 Menu 3.5 Wireless LAN Setup

The following table describes the fields in this menu.

Menu 3.5 - Wireless LAN Setup

                  Edit MAC Address Filter= N/A
   Operating Mode= Bridge / Repeater Edit Roaming Configuration= N/A
                  Edit SSID Profile= N/A
   Hide Name (SSID)= N/A        Select SSID Profile= N/A
   Channel ID= CH06 2437MHz     Edit Bridge Link Configuration= No
   RTS Threshold= 2432        Preamble= Long
   Frag. Threshold= 2432        802.11 Mode= Mixed
                  Max. Frame Burst= 650

                  Breathing LED= Yes
                  Block Intra-BSS Traffic= No
                  Output Power= <11b>17dBm/<11g>13dBm
                  Edit Layer-2 Isolation= N/A

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Table 64 Menu 3.5 Wireless LAN Setup

FIELD

DESCRIPTION

Operating Mode

Press [SPACE BAR] and select Access Point, Bridge / Repeater, AP + Bridge or

MESSID.
This field is not available on all models.

Name (SSID)

The SSID (Service Set IDentity) identifies the AP to which the wireless stations associate.

Wireless stations associating to the AP must have the same SSID. Enter a descriptive

name of up to 32 printable 7-bit ASCII characters.
This field is only available when you select Access Point or AP + Bridge in the Operating

Mode field.

Hide Name (SSID)

Press [SPACE BAR] and select Yes to hide the SSID in the outgoing data frame so an

intruder cannot obtain the SSID through scanning.

Channel ID

Press [SPACE BAR] to select a channel. This allows you to set the operating frequency/

channel depending on your particular region.

RTS Threshold

Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value between 800

and 2432.

Frag. Threshold

This is the maximum data fragment size that can be sent. Enter a value between 256 and

2432.

Edit MAC Address Filter Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 3.5.1 - WLAN

MAC Address Filter.

Edit Bridge Link

Configuration

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.4 - Bridge Link

Configuration.

Edit Roaming

Configuration

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.2 - Roaming

Configuration. This field is not available when you select Bridge / Repeater in the

Operating Mode field.