ZyXEL Communications NBG6503 User Manual

 Chapter 22 Maintenance

NBG6503 User’s Guide

Note: If you uploaded the default configuration file you may need to change the IP 

address of your computer to be in the same subnet as that of the default Router IP 

address (192.168.1.2). See 

 for details on how to set up 

your computer’s IP address.

System restart allows you to reboot the Router without turning the power off. 

Click Maintenance > Restart to open the following screen. 

Figure 117   Maintenance > Restart

Click Restart to have the Router reboot. This does not affect the Router's configuration.

The Sys OP Mode (System Operation Mode) function lets you configure your Router as an access 
point, wireless client or both at the same time. You can choose between Router and Access Point 
Mode depending on your network topology and the features you require from your device. 

The following describes the device modes available in your Router.

Upload 

Click Upload to begin the upload process.

Note: Do not turn off the Router while configuration file upload is in progress.

After you see a “configuration upload successful” screen, you must then wait one minute 
before logging into the Router again. The Router automatically restarts in this time causing 
a temporary network disconnect.

If you see an error screen, click Back to return to the Backup/Restore screen.

Reset

Pressing the Reset button in this section clears all user-entered configuration information 
and returns the Router to its factory defaults.

You can also press the RESET button on the rear panel to reset the factory defaults of your 
Router. Refer to the chapter about introducing the Web Configurator for more information 
on the RESET button.

Table 69   Maintenance > Backup/Restore (continued)