ZyXEL Communications G-1000 User Manual

G-1000 User’s Guide

110

Chapter 15 SNMP Configuration

This chapter shows you how to use SMT to configure SNMP on the G-1000.

To configure SNMP, select option 22 from the main menu to open Menu 22 – SNMP 
Configuration as shown next. The “community” for Get, Set and Trap fields is SNMP 
terminology for password.

The following table describes the SNMP configuration parameters.

Menu 22 - SNMP Configuration

SNMP:
  Get Community= public
  Set Community= public
  Trusted Host= 0.0.0.0
  Trap:
    Community= public
    Destination= 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

Table 47   Menu 22 SNMP Configuration

SNMP:

Get Community

Type the Get Community, which is the password for the incoming Get- and 

GetNext requests from the management station.

Set Community

Type the Set Community, which is the password for incoming Set requests from 

the management station. 

Trusted Host

If you enter a trusted host, your G-1000 will only respond to SNMP messages from 

this address. A blank (default) field means your G-1000 will respond to all SNMP 

messages it receives, regardless of source.

Trap:

Community

Type the trap community, which is the password sent with each trap to the SNMP 

manager. 

Destination

Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.