ZyXEL Communications G-1000 User Manual

G-1000 User’s Guide

Chapter 8 Remote Management Screens

73

When NAT is enabled:

• Use the G-1000’s WLAN IP address when configuring from the WLAN.
• Use the G-1000’s LAN IP address when configuring from the LAN.

There is a default system management idle timeout of five minutes (three hundred seconds). 
The G-1000 automatically logs you out if the management session remains idle for longer than 
this timeout period. The management session does not time out when a statistics screen is 
polling. You can change the timeout period in the System screen

To change your G-1000’s World Wide Web settings, click REMOTE MGMT to display the 
WWW screen. 

Figure 28   Remote Management: WWW

The following table describes the labels in this screen.

Table 25   Remote Management: WWW

WWW

Server Port

You may change the server port number for a service, if needed; however, you 

must use the same port number in order to use this service for remote 

management.

Server Access

Select the interface(s) through which a computer may access the G-1000 using this 

service.

Secured Client IP 

Address

A secured client is a “trusted” computer that is allowed to communicate with the G-

1000 using this service. 
Select All to allow any computer to access the G-1000 using this service.
Choose Selected to just allow the computer with the IP address that you specify to 

access the G-1000 using this service.