ZyXEL Communications B-2000 User Manual
ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch
10-6 Firmware and Configuration File Maintenance
Table 10-3 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host
Enter the IP address of the ZyAIR. 192.168.1.1 is the ZyAIR’s default IP address when
shipped.
shipped.
Send/Fetch
Use “Send” to upload the file to the ZyAIR and “Fetch” to back up the file on your
computer.
computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
extension) on your computer.
Remote File
This is the filename on the ZyAIR. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
configuration file, is “rom-0”.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to section 10.2.5 to read about configurations that disallow TFTP and FTP over WAN.
10.2.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
using other serial communications programs should be similar.
Step 1. Display menu 24.5 and enter “y” at the following screen.
Figure 10-3 System Maintenance – Backup Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Figure 10-4 System Maintenance – Starting Xmodem Download Screen
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...