ZyXEL Communications B-2000 User Manual
ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch
NAT
6-11
You must press [ENTER] at the bottom of the screen to save the whole set. You
must do this again if you make any changes to the set – including deleting a rule.
No changes to the set take place until this action is taken.
An End IP address must be numerically greater than its corresponding IP Start address.
If the Set Name field is left blank, the entire set will be deleted.
6.3.2 Configuring Individual Rule
In Menu 15.1.1-Address Mapping Rules, select Edit in the Action field and then selecting a rule brings
up the following menu, Menu 15.1.1.1
up the following menu, Menu 15.1.1.1
- Address Mapping Rule in which you can edit an individual rule
and configure the Type, Local and Global Start/End IPs.
Figure 6-9 Menu 15.1.1.1 - Editing/Configuring an Individual Rule in a Set
Table 6-6 Menu 15.1.1.1 - Editing/Configuring an Individual Rule in a Set
FIELD DESCRIPTION EXAMPLE
Type
Press [SPACE BAR] and then [ENTER] to select from a total of five types.
These are the mapping types discussed in Table 6-2. Server allows you to
specify multiple servers of different types behind NAT to this computer.
See Section 6.5.3 for an example.
These are the mapping types discussed in Table 6-2. Server allows you to
specify multiple servers of different types behind NAT to this computer.
See Section 6.5.3 for an example.
One-to-One
Local IP
Only local IP fields are N/A for server; Global IP fields MUST be set for
Server.
Server.
Start This is the starting local IP address (ILA).
0.0.0.0
End This is the ending local IP address (ILA). If the rule is for all local IPs, then
put the Start IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is
N/A for One-to-One and Server types.
N/A for One-to-One and Server types.
N/A
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Press ENTER to Confirm or ESC to Cancel: