ZyXEL Communications wireless n gigabit netusb router User Manual

 Chapter 29 Maintenance

NBG4615 User’s Guide

Note: If you uploaded the default configuration file you may need to change the IP 

address of your computer to be in the same subnet as that of the default NBG4615 

IP address (192.168.1.2). See 

 for details on how to set up 

your computer’s IP address.

System restart allows you to reboot the NBG4615 without turning the power off. 

Click Maintenance > Reset/Restart to open the following screen. 

Maintenance > Reset/Restart

Click Restart to have the NBG4615 reboot. This does not affect the NBG4615's configuration.

The Sys OP Mode (System Operation Mode) function lets you configure your NBG4615 as an 
access point, wireless client or both at the same time. You can choose between Router, Access 
Point Mode, Universal Repeater Mode, and WISP Mode depending on your network topology 
and the features you require from your device. 

The following describes the device modes available in your NBG4615.

Upload 

Click Upload to begin the upload process.

Note: Do not turn off the NBG4615 while configuration file upload is in progress.

After you see a “configuration upload successful” screen, you must then wait one 
minute before logging into the NBG4615 again. The NBG4615 automatically restarts 
in this time causing a temporary network disconnect.

If you see an error screen, click Back to return to the Backup/Restore screen.

Reset

Pressing the Reset button in this section clears all user-entered 
configuration information and returns the NBG4615 to its factory defaults.

You can also press the RESET button on the rear panel to reset the factory defaults 
of your NBG4615. Refer to the chapter about introducing the Web Configurator for 
more information on the RESET button.

Maintenance > Backup/Restore (continued)