ZyXEL Communications HW-D Series User Manual

P-662H/HW-D Series User’s Guide

Chapter 7 Wireless LAN

137

Start the ZyXEL utility and click the Adapter tab. Select the OTIST check box, enter the 
same Setup Key as your AP’s and click Save.

Figure 69   Example Wireless Client OTIST Screen

Yes!

If you want to configure your own WPA-PSK and have OTIST use that WPA-

PSK, you must:
•

Configure a WPA-PSK in the Wireless > General screen.

•

Clear the Yes! checkbox in the OTIST screen and click Start.

Note: If you already have a WPA-PSK configured in the 

Wireless screen, and you run OTIST with Yes! selected, 
OTIST will not replace the WPA-PSK. Clear the checkbox 
in the OTIST screen.

If you want OTIST to automatically generate a WPA-PSK, you must:
•

Change your security to No Security in the Wireless > General screen.

•

Select the Yes! checkbox in the OTIST screen and click Start.

•

The wireless screen displays an auto generated WPA-PSK and is now in 

WPA-PSK security mode. 

The WPA-PSK security settings are assigned to the wireless client when you 

start OTIST.

Start

Click Start to encrypt the wireless security data using the setup key and have 

the ZyXEL Device set the wireless station to use the same wireless settings as 

the ZyXEL Device. You must also activate and start OTIST on the wireless 

station at the same time. 
The process takes three minutes to complete.

Note: You can also start OTIST by pressing the RESET button 

for 3 seconds.

Table 43   OTIST