ZyXEL Communications 645R User Manual
Prestige 645 ADSL Internet Access Router
Hardware Installation & Setup
2-5
Figure 2-4 Connecting the Microfilter
2.6 Turning On Your Prestige
At this point, you should have connected the ADSL line, the Ethernet port and the power port to the
appropriate devices or lines. You can now turn on the Prestige by pushing the power button on. Refer to the
Read Me First for instructions on setting up your computer. The following procedure details how to telnet
into your Prestige.
appropriate devices or lines. You can now turn on the Prestige by pushing the power button on. Refer to the
Read Me First for instructions on setting up your computer. The following procedure details how to telnet
into your Prestige.
Step 1.
In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK. The Prestige should already be on when
you turn on your computer, see the Read Me First for details.
192.168.1.1” (the default IP address) and click OK. The Prestige should already be on when
you turn on your computer, see the Read Me First for details.
Step 2.
Entering the password
The login screen appears prompting you to enter the password, as shown below.
For your first login, enter the default password 1234. As you type the password, the screen displays an (X)
for each character you type.
for each character you type.
Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will
automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to
bring up the login screen again.
automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to
bring up the login screen again.
Figure 2-5 Login Screen
Enter Password : XXXX
Wall Jack
Prestige
Y -CONNECTOR
Wall
Side
Phone
Side
Microfilter