ZyXEL Communications AMG1302 User Manual
Chapter 10 Quality of Service (QoS)
AMG1302/AMG1202-TSeries User’s Guide
147
10.5 The QoS Game List Screen
Use this screen to give priority to traffic for specific games. Click Network Setting > QoS > Game
List to open the screen as shown next.
List to open the screen as shown next.
Figure 65
Network Setting > QoS > Game List
IP Precedence
Mark
Enter a range from 0 to 7 to re-assign IP precedence to matched traffic. 0 is the lowest
priority and 7 is the highest.
priority and 7 is the highest.
Type Of
Service Mark
Select a type of service to re-assign the priority level to matched traffic.
Available options are: Normal service, Minimize delay, Maximize throughput,
Maximize reliability and Minimize monetary cost.
Maximize reliability and Minimize monetary cost.
DSCP
Mark(0~63)
This field is available only when you select IP in the Ether Type field.
If you select Mark, enter a DSCP value with which the AMG1302/AMG1202-TSeries
replaces the DSCP field in the packets.
replaces the DSCP field in the packets.
If you select Unchange, the AMG1302/AMG1202-TSeries keep the DSCP field in the
packets.
packets.
802.1Q Tag
If you select Remark, select a priority level(in the Ethernet Priority field) and enter a
VLAN ID number (in the VLAN ID field) with which the AMG1302/AMG1202-TSeries
replaces the IEEE 802.1p priority field and VLAN ID of the frames.
VLAN ID number (in the VLAN ID field) with which the AMG1302/AMG1202-TSeries
replaces the IEEE 802.1p priority field and VLAN ID of the frames.
If you select Remove, the AMG1302/AMG1202-TSeries deletes the VLAN ID of the
frames before forwarding them out.
frames before forwarding them out.
If you select Add, the AMG1302/AMG1202-TSeries treat all matched traffic untagged and
add a second priority level and VLAN ID that you specify in the Ethernet Priority and
VLAN ID fields.
add a second priority level and VLAN ID that you specify in the Ethernet Priority and
VLAN ID fields.
If you select Same, the AMG1302/AMG1202-TSeries keep the Ethernet Priority and VLAN
ID in the packets.
ID in the packets.
To configure the Ethernet Priority, you can either select a priority number in the first
drop-down list box (7 is the highest and 0 is the lowest priority) or select an application
from the second drop-down list box which automatically maps to the corresponding
priority number. (Key Net Traffic: 7; Voice: 6; Video: 5;IGMP: 4; Key Data: 3)
drop-down list box (7 is the highest and 0 is the lowest priority) or select an application
from the second drop-down list box which automatically maps to the corresponding
priority number. (Key Net Traffic: 7; Voice: 6; Video: 5;IGMP: 4; Key Data: 3)
OK
Click OK to save your changes.
Cancel
Click Cancel to exit this screen without saving.
Table 44
QoS > Class Setup Add/Edit (continued)
LABEL
DESCRIPTION