ZyXEL Communications AMG1302 User Manual
Chapter 1 Introduction
AMG1302/AMG1202-TSeries User’s Guide
19
1.7 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the user name and password will be reset to
the default.
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the user name and password will be reset to
the default.
1.7.1 Using the Reset Button
1
Make sure the POWER LED is on (not blinking).
2
To set the device back to the factory default settings, press the RESET button for ten seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
1.8 Ways to Manage the AMG1302/AMG1202-TSeries
Use any of the following methods to manage the AMG1302/AMG1202-TSeries.
• Web Configurator. This is recommended for everyday management of the AMG1302/AMG1202-
TSeries using a (supported) web browser.
• FTP for firmware upgrades and configuration backup/restore.