ZyXEL Communications P-2302HW-P1 Series User Manual
P-2302HW/HWL-P1 Series User’s Guide
Chapter 18 Remote MGMT
225
Figure 122 Management > Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 99 Remote Management: SNMP
LABEL
DESCRIPTION
SNMP Configuration
Get Community
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
GetNext requests from the management station. The default is public and allows
all requests.
Set Community
Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
the management station. The default is public and allows all requests.
Trap Community
Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
SNMP manager. The default is public and allows all requests.
Trap Destination
Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
must use the same port number in order to use that service for remote
management.
Service Access
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
using this service.
Secured Client IP
Address
Address
A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the ZyXEL Device using this service.
to access the ZyXEL Device using this service.
Apply
Click Apply to save your customized settings and exit this screen.
Cancel
Click Cancel to begin configuring this screen afresh.