ZyXEL Communications G-2000 Plus User Manual

ZyAIR G-2000 Plus User’s Guide

Chapter 25 Remote Node Configuration

284

The following table describes the fields not already described in

.

Table 96   Fields in Menu 11.1 (PPPoE Encapsulation Specific)

Service Name

If you are using PPPoE encapsulation, then type the name of your PPPoE service 

here. Only valid with PPPoE encapsulation.

Authen

This field sets the authentication protocol used for outgoing calls.
Options for this field are:
•

CHAP/PAP - Your ZyAIR will accept either CHAP or PAP when requested by 

this remote node.

•

CHAP- accept CHAP only. 

•

PAP- accept PAP only. 

Telco Option

Allocated Budget The field sets a ceiling for outgoing call time for this remote node. The default for 

this field is 0 meaning no budget control. 

Period(hr)

This field is the time period that the budget should be reset. For example, if we are 

allowed to call this remote node for a maximum of 10 minutes every hour, then the 

Allocated Budget is (10 minutes) and the Period(hr) is 1 (hour).

Schedules

You can apply up to four schedule sets here. For more details please refer to the 

Call Schedule Setup chapter.

Nailed-Up 

Connection

This field specifies if you want to make the connection to this remote node a nailed-

up connection. More details are given earlier in this section.

Session Options

Idle Timeout

Type the length of idle time (when there is no traffic from the ZyAIR to the remote 

node) in seconds that can elapse before the ZyAIR automatically disconnects the 

PPPoE connection. This option only applies when the ZyAIR initiates the call.

If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen. 
Please see the appendix for information on PPTP.