ZyXEL Communications G-2000 Plus User Manual

Page of 430
ZyAIR G-2000 Plus User’s Guide
287 
Chapter 25 Remote Node Configuration
25.4  Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to 
set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between 
this remote node and the ZyAIR to prevent certain packets from triggering calls. You can 
specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. 
Note that spaces are accepted in this field. For more information on defining the filters, please 
refer to the Filters chapter. For PPPoE or PPTP encapsulation, you have the additional option 
of specifying remote node call filter sets.
Private
This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if 
the ZyAIR will include the route to this remote node in its RIP broadcasts. If set to 
Yes, this route is kept private and not included in RIP broadcast. If No, the route to 
this remote node will be propagated to other hosts through RIP broadcasts.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction from BothNone/
In Only/Out Only. See the LAN Setup chapter for more information on RIP. The 
default for RIP on the WAN side is None. It is recommended that you do not change 
this setting.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/
RIP-2M or None.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to 
establish membership in a Multicast group. The ZyAIR supports both IGMP version 1 
(IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting 
or select None to disable it. See the LAN Setup chapter for more information on this 
feature.
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] 
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press 
[ESC] at any time to cancel.
Table 98   Remote Node Network Layer Options
FIELD
DESCRIPTION