ZyXEL Communications 782R User Manual
Prestige 782R G.SHDSL Router
Remote Node Configuration
4-1
Chapter 4
Remote Node Configuration
This chapter covers the parameters that are protocol-independent. The protocol-dependent
configuration (TPP/IP, IPX and Bridging) is covered in the next chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use Menu 4 to set up Internet
access, you are configuring one of the remote nodes.
gateway and the network behind it across a WAN connection. When you use Menu 4 to set up Internet
access, you are configuring one of the remote nodes.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 11 Remote Node Setup.
Step 2. When Menu 11 appears as shown in the following figure, type the number of the remote node
Step 1. From the Main Menu, select menu option 11 Remote Node Setup.
Step 2. When Menu 11 appears as shown in the following figure, type the number of the remote node
that you want to configure.
Figure 4-1 Menu 11 – Remote Node Setup
Menu 11 - Remote Node Setup
1. ChangeMe (ISP)
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
9. ________
10. ________
11. ________
12. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
9. ________
10. ________
11. ________
12. ________
Enter Node # to Edit: