ZyXEL Communications ZyWALL 300 User Manual

Chapter 10 Interface

ZyWALL USG 300 User’s Guide

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP 
settings, and ping check for each bridge interface. To access this screen, click the Add icon at 
the top of the Add column in the Bridge Summary screen, or click an Edit icon in the Bridge 
Summary screen. The following screen appears.

IP Address

This field displays the current IP address of the interface. If the IP address is 
0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) 
or dynamically assigned (DHCP). IP addresses are always static in virtual 
interfaces.

Member

This field displays the Ethernet interfaces and VLAN interfaces in the bridge 
interface. It is blank for virtual interfaces.

Add icon

This column lets you create, edit, remove, activate, and deactivate interfaces.
To create a bridge interface, click the Add icon at the top of the column. The 
Bridge Add/Edit screen appears.
To create a virtual interface, click the Add icon next to the corresponding bridge 
interface. The Virtual Interface Add/Edit screen appears. See 

.

To edit an interface, click the Edit icon next to it. The Bridge Add/Edit screen 
or Virtual Interface Add/Edit screen appears accordingly.
To remove an interface, click the Remove icon next to it. The ZyWALL confirms 
you want to remove it before doing so.
To activate or deactivate an interface, click the Active icon next to it.  Make sure 
you click Apply to save and apply the change. 

Apply

Click Apply to save your changes back to the ZyWALL.

Reset

Click Reset to begin configuring this screen afresh.

Table 57   Network > Interface > Bridge (continued)