ZyXEL Communications 782M User Manual
P782M G.SHDSL Bridge
2.2.3 LAN 10/100M Port
Ethernet 10Base-T/100Base-T networks use Shielded Twisted Pair (STP) cable with RJ-45 connectors that
look like a bigger telephone plug with 8 pins. Use the crossover cable to connect your Prestige to a
computer directly or use a straight-through Ethernet cable to connect to an external hub, then connect one
end of the straight-through cable from the hub to the NIC on the computer.
look like a bigger telephone plug with 8 pins. Use the crossover cable to connect your Prestige to a
computer directly or use a straight-through Ethernet cable to connect to an external hub, then connect one
end of the straight-through cable from the hub to the NIC on the computer.
When the Prestige is on and properly connected to a computer or a hub, the
corresponding LAN LED on the front panel turns on.
2.2.4 Power Port
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.
To avoid damage to the Prestige, make sure you use the correct power adapter.
Refer to the Power Adapter Specification Appendix for this information.
2.3 Additional Installation Requirements
• An Ethernet 10/100Base-T NIC (Network Interface Card).
• Communications software configured as follows:
• Communications software configured as follows:
VT100 terminal emulation
9600 baud
parity set to none, 8 data bits, 1 stop bit
flow control set to none
2.4 Turning On Your Prestige
At this point, you should have connected the xDSL, LAN 10/100M, console and power ports to the
appropriate devices. Make sure the power adapter is plugged into an appropriate power source and the
power switch (located on the back of your Prestige) is “on” (or pressed).
appropriate devices. Make sure the power adapter is plugged into an appropriate power source and the
power switch (located on the back of your Prestige) is “on” (or pressed).
2.5 Configuring Your Prestige For Internet Access
Configure your Prestige for Internet access using:
SMT (System Management Terminal). Access the SMT via:
o
LAN or WAN using Telnet
Hardware Installation and Initial Setup