ZyXEL Communications 650R-31/33 User Manual

Prestige 650R-31/33 ADSL Router 

4-4  

Remote 

Node 

Configuration 

Encapsulation 

PPPoE (Point-to-Point Protocol over Ethernet). 
PPPoA refers to RFC-2364 (PPP Encapsulation over ATM 
Adaptation Layer 5).  
If RFC-1483 (Multiprotocol Encapsulation over ATM Adaptation 
Layer 5) or ENET ENCAP are selected,  
then the Rem Login, Rem Password, My Login and My 
Password Options and Authen fields are not applicable (N/A). 

ENET ENCAP 

 

Multiplexing 

Press [SPACE BAR] and then [ENTER] to select the method of 
multiplexing that your ISP uses, either VC-based or LLC-based. 

Service Name 

When using PPPoE encapsulation, type the name of your PPPoE 
service here.  

 

Incoming: 

Rem Login 

Type the login name that this remote node will use to call your 
Prestige. The login name and the Rem Password will be used to 
authenticate this node. 

 
 

Rem Password  Type the password used when this remote node calls your 

Prestige. 

 

Outgoing: 

My Login 

 
Type the login name assigned by your ISP when the Prestige 
calls this remote node. 

 

My Password  Type the password assigned by your ISP when the Prestige calls 

this remote node. 

 

This field sets the authentication protocol used for outgoing calls. 
Options for this field are: 

 

CHAP/PAP – Your Prestige will accept either CHAP or PAP when 
requested by this remote node. 

 

CHAP – accept CHAP (Challenge Handshake Authentication 
Protocol) only. 

Authen 

PAP – accept PAP (Password Authentication Protocol) only. 

Route 

This field determines the protocol used in routing. Options are IP 
and None. 

Bridge 

When bridging is enabled, your Prestige will forward any packet 
that it does not route to this remote node; otherwise, the packets 
are discarded. Select Yes to enable and No to disable. 

No 

Edit IP/Bridge 

Press [SPACE BAR] to select Yes and press [ENTER] to display 
Menu 11.3 – Remote Node Network Layer Options. 

No