ZyXEL Communications Wireless Gateway Series User Manual
ZyAIR Wireless Gateway Series User’s Guide
Introducing the Web Configurator
2-3
2.3.2 Uploading a Configuration File via Console Port
This method is only applicable to ZyAIR models with a console port, such as the ZyAIR B-2000.
Step 1.
Step 1.
Download the default configuration file from the ZyAIR FTP site, unzip it and save it in a folder.
Step 2.
Turn off the ZyAIR, begin a terminal emulation software session and turn on the ZyAIR again.
When you see the message "Press any key to enter Debug Mode within 3 seconds", press any key
to enter debug mode.
When you see the message "Press any key to enter Debug Mode within 3 seconds", press any key
to enter debug mode.
Step 3.
Enter "y" at the prompt below to go into debug mode.
Step 4.
Enter "atlc" after "Enter Debug Mode" message.
Step 5.
Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6.
Click Transfer, then Send File to display the following screen.
Figure 2-3 Example Xmodem Upload
Step 7.
After successful firmware upload, enter "atgo" to restart the ZyAIR.
Type the configuration file’s
location, or click Browse…
to search for it.
location, or click Browse…
to search for it.
Choose the Xmodem
protocol.
protocol.
Then click Send.