ZyXEL Communications P-2608HWL-Dx Series User Manual

P-2608HWL-Dx Series User’s Guide

130

Chapter 9 Wireless LAN

Figure 66   Advanced

The following table describes the labels in this screen. 

Use this screen to set up and start OTIST on the ZyXEL Device in your wireless network.To 
open this screen, click Network > Wireless LAN > OTIST.

Table 40   Wireless LAN: Advanced

Wireless Advanced Setup

RTS/CTS 

Threshold

Enter a value between 0 and 2432. If you select the G+ Enhanced checkbox a value 

of 4096 is displayed. 

Fragmentation 

Threshold

It is the maximum data fragment size that can be sent. Enter a value between 256 and 

2432. If you select the G+ Enhanced checkbox a value of 4096 is displayed.  

Preamble

Select a preamble type from the drop-down list menu. Choices are Long, Short or 

Dynamic. The default setting is Long. See the appendix for more information.

802.11 Mode

Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to 

associate with the ZyXEL Device.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to 

associate with the ZyXEL Device.
Select Mixed to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN devices 

to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device 

might be reduced. 

Enable 

802.11g+ mode

Select Enable 802.11g+ mode checkbox to allow any ZyXEL WLAN devices that 

support this feature to associate with the ZyXEL Device at higher transmission 

speeds. This permits the ZyXEL Device to transmit at a higher speed than the 

802.11g Only mode.

Back

Click this to return to the previous screen without saving changes.

Apply

Click Apply to save your changes back to the ZyXEL Device.

Cancel

Click Cancel to reload the previous configuration for this screen.