ZyXEL Communications P-660HN-F1 User Manual

Chapter 15 Quality of Service (QoS)

P-660HN-F1 User’s Guide

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows 
according to specific criteria such as the source address, destination address, source port 
number, destination port number or incoming interface. For example, you can configure a 
classifier to select traffic from the same protocol port (such as Telnet) to form a flow.

Click Advanced > QoS > Class Setup to open the following screen.

Figure 139   Advanced > QoS > Class Setup

The following table describes the labels in this screen.  

Use this screen to configure a classifier. Click the Add button or the Edit icon in the Modify 
field to display the following screen. 

Table 84   Advanced > QoS > Class Setup

Create a new Class

Click this to create a new classifier.

No

This is the number of each classifier. The ordering of the classifiers is important 
as the classifiers are applied in turn.

Active

Select the check box to enable this classifier.

Name

This is the name of the classifier.

Interface

This shows the interface from which traffic of this classifier should come.

Priority

This is the priority assigned to traffic of this classifier.

Filter Content

This shows criteria specified in this classifier.

Modify

Click the Edit icon to go to the screen where you can edit the classifier.
Click the Remove icon to delete an existing classifier.

Apply

Click this to save your changes.

Cancel

Click this to restore your previously saved settings.