ZyXEL Communications USG 2000 User Manual
Chapter 13 Interfaces
ZyWALL USG 2000 User’s Guide
328
Figure 263 Configuration > Network > Interface > Auxiliary
Each field is described in the table below.
Table 73 Configuration > Network > Interface > Auxiliary
LABEL
DESCRIPTION
General Settings
Enable
Interface
Select this to turn on the auxiliary dial up interface. The interface
does not dial out, however, unless it is part of a trunk and load-
balancing conditions are satisfied.
does not dial out, however, unless it is part of a trunk and load-
balancing conditions are satisfied.
Interface
Properties
Properties
Zone
This field is read-only and displays the zone to which the auxiliary
interface belongs.
interface belongs.
Description
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be
up to 60 characters long.
Port Speed
Select the speed of the connection between the ZyWALL and external
computer.
computer.
Dialing Type
Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
Initial String
Enter the AT command string to initialize the external modem.
ATZ
is
the most common string, but you should check the manual for the
external modem for additional commands.
external modem for additional commands.
Auxiliary
Configuration
Configuration