ZyXEL Communications P-324 User Manual

Prestige 324 Intelligent Broadband Sharing Gateway 

Remote Node Setup 

9-9 

broadcasts. 

RIP 

Press the [SPACE BAR] to select the RIP direction. Options are: 
Both, None, In Only, Out Only or None. Please see the RIP Setup 
section for more information on RIP. The default for RIP on the WAN 
side is None. It is recommended that you do not change this setting. 

(default) 

Version  Press the [SPACE BAR] to select the RIP version. Options are RIP-

1, RIP-2B or RIP-2M. 

Multicast 

IGMP (Internet Group Multicast Protocol) is a session-layer protocol 
used to establish membership in a Multicast group. The Prestige 
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2). 
Press [SPACE BAR] to enable IP Multicasting or select None to 
disable it. See the previous Part for more information on this feature. 

Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to 
menu 11. Press [ENTER] at the message “Press ENTER to Confirm...” to save your configuration, 
or press [ESC] at any time to cancel. 

Move the cursor to the field Edit Filter Sets in menu 11.1, then press the [SPACE BAR] to set the value to 
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.  

Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote 
node and the Prestige to prevent certain packets from triggering calls. You can specify up to 4 filter sets 
separated by commas, e.g., 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For 
more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP 
Encapsulation, you can also specify remote node call filter sets.