ZyXEL Communications MES3500-24 User Manual

Chapter 38 Access Control

MES3500-24/24F User’s Guide

Click Management > Access Control > SNMP to view the screen as shown. Use this screen to 
configure your SNMP settings.

Management > Access Control > SNMP 

The following table describes the labels in this screen. 

Management > Access Control > SNMP 

General Setting

Use this section to specify the SNMP version and community (password) values.

Version

Select the SNMP version for the Switch. The SNMP version on the Switch must match the 
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or 
both (v3v2c). 

Note: SNMP version 2c is backwards compatible with SNMP version 1.

Get Community

Enter the Get Community string, which is the password for the incoming Get- and 
GetNext- requests from the management station.

The Get Community string is only used by SNMP managers using SNMP version 2c or 
lower.

Set Community

Enter the Set Community, which is the password for incoming Set- requests from the 
management station. 

The Set Community string is only used by SNMP managers using SNMP version 2c or 
lower.

Trap Community

Enter the Trap Community string, which is the password sent with each trap to the 
SNMP manager.

The Trap Community string is only used by SNMP managers using SNMP version 2c or 
lower.

Trap Destination

Use this section to configure where to send SNMP traps from the Switch.

Version

Specify the version of the SNMP trap messages.