ZyXEL Communications MES3500-24 User Manual

 Chapter 38 Access Control

MES3500-24/24F User’s Guide

You can specify a group of one or more “trusted computers” from which an administrator may use a 
service to manage the Switch. Click Access Control to return to the Access Control screen. 

Management > Access Control > Remote Management 

The following table describes the labels in this screen. 

Management > Access Control > Remote Management

Entry

This is the client set index number. A “client set” is a group of one or more “trusted 
computers” from which an administrator may use a service to manage the Switch.

Active

Select this check box to activate this secured client set. Clear the check box if you wish to 
temporarily disable the set without deleting it. 

Start Address

End Address

Configure the IP address range of trusted computers from which you can manage this 
Switch.

The Switch checks if the client IP address of a computer requesting a service or protocol 
matches the range set here. The Switch immediately disconnects the session if it does not 
match.

Telnet/FTP/
HTTP/ICMP/
SNMP/SSH/
HTTPS

Select services that may be used for managing the Switch from the specified trusted 
computers.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these 
changes if it is turned off or loses power, so use the Save link on the top navigation panel to 
save your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.