ZyXEL Communications ZyWALL 1000 User Manual

Chapter 33 Device HA

ZyWALL USG 1000 User’s Guide

The VRRP Group Add/Edit screen allows you to add VRRP groups to the ZyWALL or to 
edit the configuration of an existing VRRP group.

• You can only use interfaces that have static IP addresses. In addition, you should set the 

static IP address to the IP address of the virtual router.

• You can only enable one VRRP group for each interface.
• You can only have one active VRRP group for each virtual router (VR ID).

To access this screen, go to the VRRP Group summary screen (see 

), and click either the Add icon or an Edit icon.

Figure 367   Device HA > VRRP Group > Edit

The following table describes the labels in this screen.  

Apply

Click Apply to save your changes back to the ZyWALL.

Reset

Click Reset to begin configuring this screen afresh.

Table 152   Device HA > VRRP Group (continued)

Table 153   Device HA > VRRP Group > Edit

Enable

Select this to make the specified interface part of the virtual router. Clear this to 

take the specified interface out of the virtual router.

Name

This field is read-only if you are editing the VRRP group. Type the name of the 

VRRP group. This field must be unique in the ZyWALL, but it is not used in the 

virtual router. The virtual router uses the VRID. The name can consist of 

alphanumeric characters, the underscore, and the dash and may be up to fifteen 

characters long.