ZyXEL Communications 5 Series User Manual

 Chapter 33 Maintenance Screens

ZyWALL 5/35/70 Series User’s Guide

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a 
.bin extension, for example, “zywall.bin”. The upload process uses HTTP (Hypertext Transfer 
Protocol) and may take up to two minutes. After a successful upload, the system will reboot. 
See

 

 for upgrading firmware using FTP/TFTP commands.

Click MAINTENANCE > F/W UPLOAD. Follow the instructions in this screen to upload 
firmware to your ZyWALL. 

1

Only upload firmware for your specific model!

Figure 348   MAINTENANCE > Firmware Upload

The following table describes the labels in this screen.

Bridge

When the ZyWALL is in bridge mode, there is no need to select or clear this 
radio button.

IP Address

Click Bridge to go to the Bridge screen where you can view and/or change the 
bridge settings.

Apply

Click Apply to save your changes back to the ZyWALL. After you click Apply, 
please wait for one minute and use the IP address you configured in the LAN 
Interface IP Address field to access the ZyWALL again.

Reset

Click Reset to begin configuring this screen afresh.

Table 203   MAINTENANCE > Device Mode (Bridge Mode) (continued)

Table 204   MAINTENANCE > Firmware Upload

File Path 

Type in the location of the file you want to upload in this field or click Browse ... to find it.

Browse... 

Click Browse... to find the .bin file you want to upload. Remember that you must 
decompress compressed (.zip) files before you can upload them. 

Upload 

Click Upload to begin the upload process. This process may take up to two minutes.