ZyXEL Communications 5 Series User Manual

Chapter 42 Remote Node Setup

ZyWALL 5/35/70 Series User’s Guide

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to 
set the value to Yes. Press [ENTER] to open Menu 11.1.4 - Remote Node Filter. 

Use menu 11.1.4 to specify the filter set(s) to apply to the incoming and outgoing traffic 
between this remote node and the ZyWALL to prevent certain packets from triggering calls. 
You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter 
field. Note that spaces are accepted in this field. For more information on defining the filters, 
please refer to 

. For PPPoE or PPTP encapsulation, you have the 

additional option of specifying remote node call filter sets.

NAT Lookup 
Set

If you select SUA Only in the Network Address Translation field, it displays 255 and 
indicates the SMT will use the pre-configured Set 255 (read only) in menu 15.1.
If you select Full Feature or None in the Network Address Translation field, it 
displays 1, 2 or 3 and indicates the SMT will use the pre-configured Set 1 in menu 
15.1 for the first WAN port,  Set 2 in menu 15.1 for the second WAN port and Set 3 for 
the Backup port. 
Refer to 

 for more information.

Metric

Enter a number from 1 to 15 to set this route’s priority among the ZyWALL’s routes 
(see 

). The smaller the number, the higher priority the route has.

Private

This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if 
the ZyWALL will include the route to this remote node in its RIP broadcasts. If set to 
Yes, this route is kept private and not included in RIP broadcast. If No, the route to this 
remote node will be propagated to other hosts through RIP broadcasts.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP direction from Both/ None/In 
Only/Out Only. See

 

 for more information on RIP. The default 

for RIP on the WAN side is None. It is recommended that you do not change this 
setting.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/
RIP-2M or None.

Multicast

IGMP (Internet Group Management Protocol) is a network-layer protocol used to 
establish membership in a Multicast group. The ZyWALL supports both IGMP version 
1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting 
or select None to disable it. See

 

 for more information on this 

feature.

Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] 
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or 
press [ESC] at any time to cancel.

Table 238   Remote Node Network Layer Options Menu Fields (continued)