ZyXEL Communications 5 Series User Manual
Chapter 44 Network Address Translation (NAT)
ZyWALL 5/35/70 Series User’s Guide
679
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule
4, old rule 6 becomes rule 5 and old rule 7 becomes rule 6.
4, old rule 6 becomes rule 5 and old rule 7 becomes rule 6.
"
You must press [ENTER] at the bottom of the screen to save the whole set.
You must do this again if you make any changes to the set – including deleting
a rule. No changes to the set take place until this action is taken.
You must do this again if you make any changes to the set – including deleting
a rule. No changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu,
Menu 15.1.1.1
Menu 15.1.1.1
- Address Mapping Rule in which you can edit an individual rule and
configure the Type, Local and Global Start/End IPs.
"
An IP End address must be numerically greater than its corresponding IP Start
address.
address.
Table 242 Fields in Menu 15.1.1
FIELD
DESCRIPTION
Set Name
Enter a name for this set of rules. This is a required field. If this field is left blank, the entire
set will be deleted.
set will be deleted.
Action
Press [SPACE BAR] to choose from None, Edit, Insert Before, Delete, Go To Rule,
Next Page or Previous Page and then press [ENTER]. You must select a rule in the next
field when you choose the Edit, Insert Before, Delete or Go To Rule commands.
None disables the Select Rule item.
Use Edit to create or edit a rule.
Use Insert Before to insert a rule before the rule selected.
Use Delete to delete the selected rule and then all the rules after the selected one will be
advanced one rule.
Use Go To Rule to view the page where your desired rule is listed.
Select Next Page or Previous Page to view the next or previous page of rules
(respectively).
Next Page or Previous Page and then press [ENTER]. You must select a rule in the next
field when you choose the Edit, Insert Before, Delete or Go To Rule commands.
None disables the Select Rule item.
Use Edit to create or edit a rule.
Use Insert Before to insert a rule before the rule selected.
Use Delete to delete the selected rule and then all the rules after the selected one will be
advanced one rule.
Use Go To Rule to view the page where your desired rule is listed.
Select Next Page or Previous Page to view the next or previous page of rules
(respectively).
Select
Rule
Rule
When you choose Edit, Insert Before or Delete in the previous field the cursor jumps to
this field to allow you to select the rule to apply the action in question.
this field to allow you to select the rule to apply the action in question.