ZyXEL Communications max208m User Manual
Chapter 8 Security
WiMAX Device Configuration User’s Guide
132
Click Security > PPTP VPN > PPTP Client > Add to open this screen as shown next.
Figure 73
PPTP Client: Add
This screen contains the following fields:
Table 55
PPTP Client: Add
LABEL
DESCRIPTION
Profile Name
Enter the name for this client connection.
NAT Mode?
Select Yes if the client will be located behind a NAT enabled router. This will
allow multiple clients using NAT to connect with PPTP at the same time.
allow multiple clients using NAT to connect with PPTP at the same time.
Auth Protocol
Select the Authentication Protocol allowed for the connection. Options are:
•
PAP - Password Authentication Protocol (PAP) authentication occurs in clear
text and does not use encryption. It’s probably not a good idea to rely on this
for security.
•
CHAP - Challenge Handshake Authentication Protocol (CHAP) provides
authentication through a shared secret key and uses a three way handshake.
•
MSCHAPv1 - Microsoft CHAP v1 (MSCHAPv1) provides authentication
through a shared secret key and uses a three way handshake. It provides
improved usability with Microsoft products.
•
MSCHAPv2 - Microsoft CHAP v2 (MSCHAPv2) provides encryption through a
shared secret key and uses a three way handshake. It provides additional
security over MSCHAPv1, including two-way authentication.
MPPE Encryption
If MSCHAPv1 or MSCHAPv2 is selected as an Auth Protocol, use the drop-
down list box to select the type of Microsoft Point-to-Point Encryption (MPPE).
Options are:
down list box to select the type of Microsoft Point-to-Point Encryption (MPPE).
Options are:
•
MPPE 40 - MPPE with 40 bit session key length.
•
MPPE 128 - MPPE with 128 bit session key length.
•
Auto - Automatically select either MPPE 40 or MPPE 128.
MPPE Stateful?
Select Yes to enable stateful MPPE encryption. This can increase performance
over stateless MPPE, but should not be used in lossy network environments like
layer two tunnels over the Internet.
over stateless MPPE, but should not be used in lossy network environments like
layer two tunnels over the Internet.
Server IP Address Enter the IP address of the PPTP server.
User Name
Enter the user name for connecting to the PPTP server.
Password
Enter the password for connecting to the PPTP server.
Retype
Retype the password for connecting to the PPTP server.